Part Premiere: RB3008-Center Frame with Skid Plate Mount

Introducing our Center Section with Skid Plate Mount (RB3008L & RB3008R) for your TJ Wrangler.

One of the most important parts of any vehicle is the skid plate.  This vital piece of armor protects and retains your transmission and transfer case. Damage to either of these more or less means you’ve totalled your vehicle.  Not only is the health of the skid plate important, but also its contact points with the rest of the frame.

The skid plate is secured to the bottom of your TJ’s center frame sections.  This area is notorious for being one of the first frame areas to start deteriorating and rusting away.  This is due to its lower location and several frame hole openings which allow water and debris to enter and then rest at the bottom of the section.  Combined with the sheer weight of the skid plate, and the fragility of a rusty frame, it’s very likely that the plate would rip itself off with even minor impact or shaking.

Our Center Section runs the length of your frame, from control arm to control arm, and even comes with the bolts, nuts, and washers to re-secure your skid plate.

You can pick up your own Center Frame Section with Skid Plate Mount at the link below.  And when you do, be sure to check out our fully written instructions or our start to finish video walkthrough!  

Take control of your own restoration, with Rust Buster Frameworks!


Share this post



← Older Post Newer Post →